Havis Shields Work Light CD CL HID 1 User Manual

CD-CL-HID-1 INSTRUCTIONS  
COLLINS PORTABLE HID SPOTLIGHT  
Warning: Please read all instructions and warnings prior to installation. Power must be disconnected  
prior to installation or servicing. This luminaire must be installed and operated per NFPA 70 National  
Electric Code, and all applicable codes and regulations. These instructions are provided as a guideline  
for proper installation, and do not purport to cover every possible installation scenario or  
configuration. If questions arise, consult the factory.  
OPERATING INSTRUCTIONS:  
1. General Notes:  
This light is intended for handheld use only. It is equipped with a 12 VDC cigarette  
lighter plug adapter.  
The light is shipped with a bi-modal switch. The middle position is off. Pressing UP  
turns the light ON momentarily, Pressing DOWN turns the light ON to stay on.  
Do not leave the light turned on unattended.  
The lens can become very hot during operation, and can cause burns to skin and  
objects. Never touch the lens, and do not allow any objects to touch the lens during  
operation.  
MAINTENANCE & USAGE RECOMMENDATIONS:  
2. Lamp and Ballast Maintenance:  
Make sure power is off before performing any maintenance on the fixture. HID  
fixtures produce extremely high voltage (greater than 24,000V) during operation.  
Remove the lensframe screw and nut, and set them aside for reuse later.  
Gently flex the lensframe outward, and pull it straight off. Be careful not to twist or  
deform the lensframe when removing it.  
The lamp is attached to the reflector with one screw. If the lamp requires  
replacement, then simply remove the mounting screw, replace the old lamp with a  
new one, and replace the mounting screw. Make sure that the new lamp is oriented in  
the same direction as the old lamp.  
The lamp and ballast are connected by wires with quick-connects. If any of these  
wires are damaged, then both the ballast and lamp must be replaced. Do not attempt  
to repair damaged wires.  
The ballast is held in place with a flexible bracket. To remove the ballast, simply  
spread the bracket, and pull the ballast straight out. Install a new ballast by spreading  
the bracket and pushing the ballast straight in until it clicks and locks in place.  
When maintenance has been completed, first ensure that all connections are secured  
properly before proceeding.  
 

Grundig Vacuum Cleaner VCC9850 User Manual
Haier Refrigerator HVTM18DABB User Manual
Halo Lighting System Indoor Furnishings H2586 User Manual
Hamilton Electronics Portable DVD Player MV 9700 User Manual
Harbor Freight Tools Saw 68978 User Manual
HP Hewlett Packard Laptop ze2401xt User Manual
HP Hewlett Packard Network Hardware T1453 90001 User Manual
HP Hewlett Packard Personal Computer dx2250 User Manual
IBM Ricoh Printer 1612 User Manual
Impex Home Gym MD PWR 8 User Manual