DYNAMIX HP-30 COAX
128 Mbps
HPNA 3.0 over Coax Ethernet Bridge
User’s Guide
HARDWARE INSTALLATION
Parts Names and Functions
LED Indicators on the Front Panel
Ports on the Rear Panel
Essential Hardwares
Hardware Connections
1. Select a convenient location for the bridge near the PC or Ethernet device to which it will be
connected. The bridge should be kept away from excessive heat.
2. Using one coaxial cable to connect the HCNA port to F-Type connector on the wall. Using
another coaxial cable to connect the other F-type TV port to TV set.
3. Connect the LAN1/LAN2 port to your Ethernet equipped device.
4. Connect the power adapter to the DC5V port into a wall outlet.
The figure above shows how to connect an xDSL modem to a home coaxial cable network. Follow
the same steps to connect any Ethernet device such as a HUB or printer, to a coaxial cable network.
Now you should have connected the LAN port, HCNA port and the DC5V port to the appropriate
devices or lines. LED will be as:
POWER ON
LAN Link/Act ON
HCNA Link/Act ON
HCNA SyncMode ON
For more information on LEDs, see section
"LED Indicators on the Front Panel"
TROUBLESHOOTING
The bridge has been designed to be a reliable and easy to use connection device. Please refer to the
list below to aid in troubleshooting.
The Power (green) LED is off.
ꢀ Make sure the power adapter is properly plugged into a live electrical outlet.
The LAN(Ethernet) or HCNA Link/Act LED is off.
ꢀ Make sure the connection to these two ports is secure.
ꢀ The Ethernet or HCNA device to which you are connected should be powered on and properly
configured
.
The HCNA SyncMode LED is off.
ꢀ The LED should be always ON after power on.
ꢀ The Ethernet or HCNA device to which you are connected should be powered on and properly
configured.
SPECIFICATIONS
Standards
ꢀ IEEE 802.3 10BaseT Ethernet compliant
ꢀ IEEE 802.3u 100BaseT Fast Ethernet compliant
ꢀ HomePNA 3.0 over Coax (HCNA) compliant
Data Rates
ꢀ HCNA: 128 Mbps
ꢀ Ethernet: 10/100 Mbps
Distances
ꢀ HCNA : 1200 meter maximum between the two farthest nodes on LAN
ꢀ Ethernet: 100 meter maximum
Power Consumption:
ꢀ 5V DC IN, Less than 4 watt
Certifications
ꢀ CE, FCC Part 15
LEDs
ꢀ Power
ꢀ Ethernet Link/Activity
ꢀ HCNA Link/Activity; SyncMode
Connectors
ꢀ Two F-Type connectors, one for connecting with HCNA device, and one for TV
ꢀ Two RJ-45 for 10/100M Ethernet
Cables
ꢀ HCNA Network: F-Type RG-59U coaxial cable
ꢀ Fast Ethernet: CAT5 or better UTP
|