+
AGES 4
™
34561 Asst.
®
Removing protective display case and floor/figure:
COVER
Note: You will need a Phillips/cross head screwdriver (not included)
for removing/assembling parts.
1. Remove the two outside screws on the bottom of the base
as shown to loosen and detach the protective display case.
Discard screws.
FIGURE/
FLOOR
2. Remove the four screws on the bottom of the base as shown to
loosen the floor/figure.
3. Once you have removed the floor (with the figure attached)
from the base, you may reposition the figure/floor to face his or
her nameplate, or to face the “Titanium Series” logo. Replace
screws to hold floor/figure in place.
4. Replace cover onto base to cover figure/floor.
OUTSIDE
SCREW
OUTSIDE
SCREW
BASE
SCREWS
BOTTOM VIEW
Visit
®*
®*
© 2005 Lucasfilm Ltd. & ® or TM where indicated. All rights reserved.
®* and/or ™* & © 2005 Hasbro.
TM & ® denote U.S.Trademarks.
P/N 6543670000
Product and colors may vary.
*
*
|