CHILDREN’S PATIO SET
4 PIECE
Model 09018
ASSEMBLY and OPERATING
INSTRUCTIONS
®
3491 Mission Oaks Blvd., Camarillo, CA 93011
Copyright © 2003 by Harbor Freight Tools®. All rights reserved. No portion of this
manual or any artwork contained herein may be reproduced in any shape or form
without the express written consent of Harbor Freight Tools .
For technical questions and replacement parts, please call 1-800-444-3353
9. Maintain the Patio Set with care. Keep it clean for better and safer performance.
Inspect the Patio Set periodically, and if damaged, have it repaired by an authorized
technician.
10. Stay alert. Watch what you are doing, use common sense. Do not assemble the
Patio Set when you are tired.
11. Check for damaged parts. Before using the Patio Set, any part that appears
damaged should be carefully checked to determine that it will operate properly and
perform its intended function. Check for alignment and binding of moving parts; any
broken parts or mounting fixtures; and any other condition that may affect proper
operation. Any part that is damaged should be properly repaired or replaced by a
qualified technician.
12. Replacement parts and accessories. When servicing, use only identical
replacement parts. Use of any other parts will void the warranty.
13. Do not assemble the Patio Set if under the influence of alcohol or drugs. Read
warning labels if taking prescription medicine to determine if your judgement or
reflexes are impaired while taking drugs. If there is any doubt, do not assemble the
Patio Set.
14. Choose the proper location. Set up the Patio Set on a flat, dry, level surface.
15. Be aware of weather conditions. Make sure the umbrella is tied in the closed
position or removed entirely during windy weather. The wind can knock over the
umbrella and table causing serious injury.
16. Maintenance. For your safety, maintenance should be performed regularly by a
qualified technician.
Warning: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be under-
stood by the operator that common sense and caution are factors which cannot be
built into this product, but must be supplied by the operator.
WARNING: The brass components of this product contain lead, a chemical
known to the State of California to cause birth defects (or other reproductive
harm). (California Health & Safety code 25249.5, et seq.)
Unpacking
When unpacking, check to make sure the parts listed on page 6 are included. If any parts
are missing or broken, please call Harbor Freight Tools at the number on the cover of this
manual as soon as possible.
Page 3
SKU 09018
Assembly
See the Parts List/Drawing on page 6.
1. Assembling the Table Stand (#1): Use two sets of Screws (#6) on each side of the
Brace (#10) to support the bottom of the Table Stand (#1). Align the Umbrella Stand (#9)
next to the Brace (#10). See FIGURE 1.
FIGURE 1
Table
Stand (#1)
Brace (#10)
Screws (#6)
Umbrella
Stand (#9)
2. Attach the two Brackets (#11) to the
underside of the Table Board (#2) using
four sets of Table Screws (#5).
See FIGURE 2.
FIGURE 2
Screws (#6)
Table
Board
(#2)
Bracket (#11)
Table Screw (#5)
FIGURE 3
3. Attach the Table Stand (#1) to
the Brackets (#11) on the
Table Board (#2) using two sets
of Screws (#6).
See FIGURES 2 & 3.
Screws (#6)
Page 4
SKU 09018
Assembly (continued)
4. Connect the Umbrella (#8) and the
FIGURE 4
Umbrella (#8)
Pole (#12) using Screw (#7). Slide the
Pole (#12) into the Umbrella Stand (#9).
See FIGURE 4.
Screw (#7)
Pole (#12)
Umbrella Stand (#9)
5. Attach the Chair Board (#4)
to the Chair Stand (#3)
using four sets of
FIGURE 5
Screws (#6).
Chair
Board
(#4)
Note: Remember to set
the Patio Set up on a
flat, dry, level surface. Do
not deploy the Umbrella (#8)
during windy conditions.
Chair Stand (#3)
Maintenance
1. Periodically check the hardware and tighten if necessary.
2. If you leave the set outdoors during inclement weather, it is recommended that you seal
the set with a marine quality varnish or paint.
Page 5
SKU 09018
Parts List
Part No.
1
2
3
4
5
6
7
8
Description
Qty.
1
1
Table Stand
Table Board
Chair Stand
Chair Board
Table Screw (6mm x 35mm)
Screw (6mm x 20mm)
Screw
2
2
4 Sets
14 Sets
1
1
1
1
2
1
Umbrella
9
Umbrella Stand
Brace
Bracket
10
11
12
Pole
#6
#9
#5
#7
#10
#11
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS
MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBU-
TOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE
OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS
QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER
AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS
SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE
BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER
REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING
OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
NOTE: Some parts are listed and shown for illustration purposes only and are not available
individually as replacement parts.
Page 6
SKU 09018
|