SOLAR CANDLE
GARDEN LANTERN
95797
ASSEmbLy AND OpERATiON iNSTRuCTiONS
Due to continuing improvements, actual product may differ slightly from the product described herein.
3491 Mission Oaks Blvd., Camarillo, CA 93011
TO pREVENT SERiOuS iNjuRy, READ AND uNDERSTAND
ALL wARNiNGS AND iNSTRuCTiONS bEfORE uSE.
©
®
Copyright 2007 by Harbor Freight Tools . All rights reserved. No portion of this
manual or any artwork contained herein may be reproduced in any shape or form
without the express written consent of Harbor Freight Tools.
for technical questions or replacement parts, please call 1-800-444-3353.
intended function. Any broken parts or mounting fixture that may affect proper operation
should be properly repaired or replaced by a qualified technician.
10.
11.
properly disponse of any used batteries. Dispose of the used batteries properly
according to the solid Waste disposal regulations in your community.
warning: The warnings, cautions, and instructions discussed in this instruction
manual cannot cover all possible conditions and situations that may occur. It must
be understood by the operator that common sense and caution are factors which cannot
be built into this product, but must be supplied by the operator.
uNpACKiNG
When unpacking, check to make sure that the item is intact and undamaged. If any
parts are missing or broken, please call Harbor Freight Tools at the number on the cover of
this manual as soon as possible.
OpERATiNG iNSTRuCTiONS
NOTE: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram on page 7.
1.
Before using, you need to charge the batteries. You can do this by placing the Solar
Lantern in the sunlight.The Lantern will take approximately 8 hours of sunlight to charge.
Be sure the four Solar Panels (2) are in full sunlight.
Solar Panels (2)
Top Assembly
Plastic Ring (11)
FIGURE 1
2.
After the Batteries (8) are charged, remove theTop Assembly (See Figure 1) by twisting
counterclockwise off the Plastic Ring (11) and lifting it off the Lantern.
Page 3
SKU 95797
for technical questions, please call 1-800-444-3353
Plastic Ring (11)
Battery (8)
Power
Switch (18)
FIGURE 2
3.
4.
The Power Switch (10) is on the underside of the Top Assembly. To have the light turn
on at night, locate the Power Switch (18) and switch to the ON position. You can turn
the Solar Candle Garden Lantern Power Switch (18) OFF if you do not want the light
to turn on at night. See Figure 2.
Replace the Top Assembly by connecting it to the Lantern, matching up the notches
and twisting clockwise for closure.
Small Loop (1)
“S” Steel Tube (19)
Middle Steel Tube (22)
Lower Steel Tube (23)
Ground
Stake (16)
FIGURE 3
5.
The Shepherd’s Hook is screwed together with three threaded shafts (19, 22 and 23).
Hook inserts into the top of the Ground Stake (16) and the Lantern hangs from the
Page 4
SKU 95797
for technical questions, please call 1-800-444-3353
hook by a Small Loop (1) at the top of the light. See Figure 3 and Assembly Drawing
on page 7.
6.
7.
Choose the location for the Solar Candle Garden Lantern and stick the Shepherd’s
Hook and Ground Stake (16) into the ground, avoiding any underground wiring or
plumbing. Be sure to choose a location that gets plenty of sunshine during the day
and is not near a porch or street light at night. See Figure 3.
If the Solar Candle Garden Lantern stops working or is not holding a charge for a long
enough period, replace the batteries with identical rechargeable NiCd “AA” batteries.
See directions below for battery replacement.
Small Loop (1)
FIGURE 4
Note: The Solar Candle Garden Lantern can be removed from the Shepherd’s Hook
and Stake and used as a table Lantern. See Figure 4.
bATTERy REpLACEmENT
1.
Turn the Top Assembly of the Solar Candle Garden Lantern slightly
counterclockwise. Remove the assembly from the top of the Solar Candle Garden
Lantern.
See Figure 1 on page 3.
2.
3.
Take assembly off the Lantern, being careful not to disturb the wires and the internal
components. See Figure 2 on page 4.
Remove the used Batteries (8) and dispose of them properly according to the Solid
Waste Disposal regulations in your community. Replace with new Rechargeable
Page 5
SKU 95797
for technical questions, please call 1-800-444-3353
NiCd Batteries (8). The polarity of the batteries is marked inside the Battery Case
(10). Be careful of the internal components and do not disturb the wires.
4.
Once the batteries are in place, match up the notches and return the Top Assembly.
Twist clockwise onto the Plastic Ring (11). Then tighten.
Note: Test that the Top Assembly and Lantern are secure before hanging on the
Shepherd’s Hook.
mAiNTENANCE
1.
2.
wARNiNG! Make sure the Power Switch (18) of the Solar Candle Garden Lantern
is in its “OFF” position before performing any inspection, maintenance, or cleaning
procedures.
bEfORE EACH uSE, inspect the general condition of the Solar Candle Garden
Lantern. Check for loose screws, cracked or broken parts, damaged electrical
wiring, and any other condition that may affect its safe operation. Do not use
damaged equipment.
3.
Clean the outside of the Solar Candle Garden Lantern with a clean and damp
cloth. Never use abrasive cleaners; they will damage the unit. You may use a mild
detergent. Never submerge the Solar Candle Garden Lantern in water or any other
liquid.
pLEASE READ THE fOLLOwiNG CAREfuLLy
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY
DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT
HE OR SHE IS qUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS
qUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR
DISTRIBUTOR ExPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE
UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER
ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL
PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION
OF REPLACEMENT PARTS THERETO.
Page 6
SKU 95797
for technical questions, please call 1-800-444-3353
pARTS LiST
part
1
Description
Small Loop
Q’ty
1
part
13
14
15
16
17
18
19
20
21
22
23
Description
Transparent Hood
Q’ty
1
4
1
1
2
1
3
1
1
1
1
2
Solar Panel
Top Cover
4
Plastic Sheet
Base
3
1
4
Top Ring
1
Ground Stake
Connector
5
Circuit Board
Battery Board
Screw
1
6
1
Power Switch
“S” Steel Tube
Stopper
7
10
2
8
Battery
9
Spring Sheet
Battery Case
Plastic Ring
Plastic Candle
4
Sensor
10
11
12
2
Middle Steel Tube
Lower Steel Tube
1
1
ASSEmbLy DiAGRAm
2
4
3
6
7
5
8
9
1
10
7
11
12
13
21
15
14
20
7
18
7
19
17
16
22
23
Note: Some parts are listed and shown for illustration purposes only and are not
available individually as replacement parts.
Page 7
SKU 95797
for technical questions, please call 1-800-444-3353
|