Harbor Freight Tools Insect Control Equipment 95500 User Manual

Solar InSect kIller  
wIth lIght  
Model 95500  
aSSeMbly & operatIng InStructIonS  
Due to continuing improvements, actual product may differ slightly from the product described herein.  
®
3491 Mission Oaks Blvd., Camarillo, CA 93011  
Visit our website at: http://www.harborfreight.com  
to preVent SerIouS Injury, read and underStand  
all warnIngS and InStructIonS before uSe.  
©
®
Copyright 2006 by Harbor Freight Tools . All rights reserved. No portion of this  
manual or any artwork contained herein may be reproduced in any shape or form  
without the express written consent of Harbor Freight Tools.  
for technical questions or replacement parts, please call 1-800-444-3353.  
 
7.  
people with pacemakers should consult their physician (s) before using this  
product. Electromagnetic fields in close proximity to a heart pacemaker could cause  
interference to or failure of the pacemaker.  
unpackIng  
When unpacking, check to make sure that the item is intact and undamaged. If any  
parts are missing or broken, please call Harbor Freight Tools at the number shown on the  
cover of this manual as soon as possible.  
aSSeMbly InStructIonS  
note: For additional information regarding the parts listed in the following pages, refer to  
the Assembly Diagram near the end of this manual on page 8.  
Installation operation  
note: The Solar Insect Killer with Light can be configured in two designs. One design is as  
a Light that resembles a Lantern. The other design is a Solar Garden Light with a  
stake that goes into the ground.  
1.  
as a Solar garden light, insert the assembled Stake (17, 18, 19, & 20) into a  
at and level surface. Choose an area where the sunlight falls directly onto the  
Solar Panel (2). Insert the sharp end of the Stake into the ground, deep enough to  
hold firmly. Be sure you have avoided any underground wiring or plumbing. Attach  
the Light firmly on the top of the Stake. See the cover photo. Make sure the area  
is not accessible to children or pets and that the area has no plant debris nearby  
that can fall on the unit.  
2.  
as a lantern design, remove the Stake. You need to place the lantern in a area  
where the Solar Panel (2) can be charged with direct sunlight while hanging. Lift the  
Hook (1) and connect it to a chain or hook from a beam or door jam. Avoid hanging  
it too low where bodily injury could happen. See Figure 3.  
SKU 95500  
for technical questions, please call 1-800-444-3353.  
Page 3  
 
Solar Panel (2)  
Figure 1  
3.  
you need to flip the Switch to off (8) and charge the Solar Insect killer with  
light when using it for the rst time. Charge time for the Solar Panel (2) is at  
least 2-3 days. After this, it will last eight hours without sunlight. Turn OFF the light  
during daylight.  
note: The Solar Insect Killer with Light can also be charged with an AC/DC adapter,  
4.5V/250mA (not included).  
note:There are three positions on the Switch (8).ON, OFF & Ultraviolet Light (that attracts  
insects to kill them). The Insect Killer position of the switch will operate 6 hours at  
a time after a full days charge. See Figure 2.  
On/Off and Ultravio-  
let Switch (8)  
Figure 2  
4.  
The power Switch (8) is located on the underside of the top cover. See Figure 2.  
SKU 95500  
for technical questions, please call 1-800-444-3353.  
Page 4  
 
Hook (1)  
Lantern Style  
Ground Stake  
(17, 18, 19, 20)  
Figure 3  
5.  
Place the lantern assembly on the top of the Ground Stake (17,18,19, 20). Be sure  
it is connected firmly. Turn the Switch (8) ON.  
replacIng the batterIeS  
note: If the light stops working after being used for a period of time, it may mean the bat-  
tery is beyond its lifespan.  
1.  
Remove the Light from the Stake. From the underside of the Light, remove the cage  
to access the batteries. Twist the cage counterclockwise and lift off to expose the  
Screws (10). Set aside. (Caution:The cage is fragile. Handle carefully). See Figures  
4 & 5.  
Underside of  
top cover  
On/off Switch (8)  
Figure 4  
2.  
With a screwdriver (not provided) remove the Screws (10) to expose the batteries.  
Tilt the Transparent Inner Hood assembly (12), containing the bulbs, carefully aside  
but still connected. Remove the batteries, being careful not to damage the wiring.  
See Figures 4 (above) and 5 on page 6.  
SKU 95500  
for technical questions, please call 1-800-444-3353.  
Page 5  
 
Transparent  
Inner Hood  
Assembly (12)  
Batteries (11)  
Battery Case (9)  
Figure 5  
3.  
4.  
Replace the dead batteries with identical AA NiCd Rechargeable Batteries (11). Be  
sure to follow the polarity signs inside of the Battery Case (9).  
Reverse these steps and reassembly the Solar Insect Killer with Light. Tighten the  
screws and replace the cage, turning clockwise. Connect assembly to the Stake.  
Turn the Switch to ON. If it does not light, check to polarity of the batteries again or  
place the Solar Light in sunlight and charge.  
5.  
Dispose of the used batteries properly by contacting your local community waste  
disposal facility.  
InSpectIon, MaIntenance, and cleanIng  
1.  
To remove dust, be sure the Switch is in the OFF position. Use a damp cloth. Dry  
with a cloth.  
2.  
3.  
This product is weather resistant but avoid standing water.  
Brush off the dried bugs with the Light in the OFF position.  
SKU 95500  
for technical questions, please call 1-800-444-3353.  
Page 6  
 
partS lISt  
part  
description  
Q’ty  
part  
11  
12  
13  
14  
15  
16  
17  
18  
19  
20  
description  
Battery  
Q’ty  
1
2
3
4
Hook  
1
1
1
1
2
1
2
1
1
1
1
1
1
1
Solar Panel  
Top Cover  
Electric Grid  
Screw  
Circuit Board  
Reflect Ring  
Reflect Board  
Outer Hood  
Upper Shaft  
Connector  
1 White  
2 Ultraviolet  
5
LED  
6
7
Control Circuit Board  
Recharge Socket  
Switch  
1
1
1
1
4
8
Lower Shaft  
Ground Stake  
9
Battery Case  
Screw  
10  
pleaSe read the followIng carefully  
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEM-  
BLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER  
OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER  
THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR  
SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER  
AND/OR DISTRIBUTOR ExPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS  
SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE  
BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS  
TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS  
OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.  
SKU 95500  
for technical questions, please call 1-800-444-3353.  
Page 7  
 
aSSeMbly dIagraM  
Solar Panel (2)  
Main Body  
Ultraviolet LED  
White LED  
Electric Grid  
Stake (17, 18, 19, 20)  
1
6
2
3
7
8
5
4
9
11  
12  
13  
10  
14  
15  
17  
18  
16  
19  
20  
record product’s Serial number here:  
note: If product has no serial number, record month and year of purchase instead.  
note: Some parts are listed and shown for illustration purposes only, and are not available  
individually as replacement parts.  
SKU 95500  
for technical questions, please call 1-800-444-3353.  
Page 8  
 

Gravely Lawn Mower 39000 User Manual
Grizzly Planer G7213Z User Manual
Haier CRT Television HTAF15 User Manual
Haier Refrigerator JC 112G 112GA User Manual
Harbor Freight Tools Binoculars 91956 User Manual
Hasbro Board Games 030901693061Ab User Manual
HP Hewlett Packard Headphones HP Bluetooth Stereo Headphones User Manual
Hughes Speaker WARP7 User Manual
Husqvarna Marine Sanitation System FS 6600 D User Manual
Husqvarna Trimmer 326HDA55X Series 326HE3X Series 326HE4 User Manual