Camping Flashlight
92061
ASSEMBLY AND OPERATING INSTRUCTIONS
3491 Mission Oaks Blvd., Camarillo, CA 93011
Copyright © 2004 by Harbor Freight Flashlights®. All rights reserved. No portion of
this manual or any artwork contained herein may be reproduced in any shape or form
without the express written consent of Harbor Freight Flashlights.
For technical questions and replacement parts, please call 1-800-444-3353
6. Maintain flashlights with care. Keep flashlights maintained and clean for
better and safer performance. Follow instructions for maintenance and
changing accessories.The handles must be kept clean, dry, and free from oil
and grease at all times.
7. Disconnect power.Turn off flashlight when not in use. Remove batteries if
flashlight is not going to be used for a long period of time.
8. Avoid unintentional starting. Be sure the switch is in the Off position when
not in use and before replacing batteries.
9. Stay alert. Watch what you are doing, use common sense. Do not operate
any flashlight when you are tired.
10. Check for damaged parts. Before using any flashlight, any part that appears
damaged should be carefully checked to determine that it will operate properly
and perform its intended function. Check for any condition that may affect
proper operation.Any part that is damaged should be properly repaired or
replaced by a qualified technician. Do not use the flashlight if the switch does
not turn On and Off properly.
11. Guard against electric shock. Prevent body contact with grounded surfaces
such as pipes, radiators, ranges, and refrigerator enclosures.
12. Do not use camping equipment if under the influence of alcohol or
drugs. Read warning labels on prescriptions to determine if your judgment or
reflexes are impaired while taking drugs. If there is any doubt, do not use this
product or other camping appliances.
13. Maintenance. For your safety, service and maintenance should be performed
regularly by a qualified technician.To maintain water resistance, be sure that
all rubber seals are not damaged and properly installed.
14. The compass contains mineral oil, which can be harmful if ingested.
Discard the flashlight if leaking or otherwise damaged, and rinse any areas
that come into contact with the oil thoroughly.
NOTE: This flashlight is water resistant, but not water proof.When properly as-
sembled and maintained, you may use it with confidence in rain or damp condi-
tions. However, if it is totally immersed in water if is likely to be damaged.
Warning: The warnings, cautions, and instructions discussed in this instruc-
tion manual cannot cover all possible conditions and situations that may oc-
SKU 92061 DowFnlooardtferocmhWniwcwa.lSqomuaensutailos.ncosm,.pAllel MaasneuaclsaSlle1a-rc8h0A0n-d44D4ow-3nl3o5ad3. Page 3
cur. It must be understood by the operator that common sense and caution are
factors which cannot be built into this product, but must be supplied by the
operator.
Unpacking
When unpacking, check to make sure the following parts are included.
Flashlight
4 filters stored in the filter compartment
Spare Krypton bulb, stored in the spare bulb compartment
If any parts are missing or broken, please call Harbor Freight Flashlights at the
number on the cover of this manual.
NOTE: Warranty replacement parts or accessories specific to this flashlight are not
available from Harbor FreightTools for this item.Replacement batteries and light
bulbs may be available at your local Harbor Freight Tools retail outlet, or are
commonly available from hardware and department stores.
Operation
First install two (2) “AA” batteries (not included).
1. Remove the battery compartment cap, located at the bottom of the flashlight,
by turning it counterclockwise.
2. Insert two “AA” batteries (not included) into the battery compartment,
observing the polarity markings on the flashlight case. Please see picture.
3. Replace the battery compartment cap, and secure it by turning clockwise until
hand tight.
SKU 92061 DowFnlooardtferocmhWniwcwa.lSqomuaensutailos.ncosm,.pAllel MaasneuaclsaSlle1a-rc8h0A0n-d44D4ow-3nl3o5ad3. Page 4
Select and install the desired lense.
1. The lenses are stored in a compartment at the bottom of the flashlight, under
the compass. Open this compartment by turning the cap counterclockwise.
2. Select the desired lense. NOTE:Your preference may vary, but suggested
lens application is: RED for very low light output, GREEN for low light output,
YELLOW for contrast in haze or fog, FROSTED for diffused light.
3. To change or install the lense, remove the
lense cover by turning counterclockwise.
Replace the existing lense with the desired
lense. Replace the lense cover, and tighten by
turning clockwise until finger tight.
To operate the flashlight:
1. To turn on the flashlight, press the upper
part of the ON /OFF switch down.
2. To turn off the flash light, press the lower
part of the ON / OFF switch down.
3. To manually blink the flashlight, press the round “blink” button and release.
Maintenance
1. When not in use, turn OFF the flashlight to save the
batteries.
2. If the flashlight will not be used for several months,
remove the batteries before storage to prevent
possible damage caused by leaking batteries.
“blink” button
ON / OFF switch
SKU 92061 DowFnlooardtferocmhWniwcwa.lSqomuaensutailos.ncosm,.pAllel MaasneuaclsaSlle1a-rc8h0A0n-d44D4ow-3nl3o5ad3. Page 5
3.
In case the bulb burns out, a
spare battery is stored in a container at
the bottom of the flashlight. Remove the
battery by turning the storage container
counterclockwise.
4.
Remove the Lantern Head by
turning it counterclockwise. Please refer
to the photo at left. Remove the Bulb
Holder from the Lantern Head by turning
it counterclockwise.
6. Remove the old bulb from the Bulb
Holder by pulling it straight out.
Place the new bulb in the Bulb
Holder, and replace the Bulb Holder
in the Lantern Head. Secure by
turning the Bulb Holder clockwise
until finger tight.
7. Replace the Lantern Head in the
Flashlight. Turn clockwise until finger
tight. Do not overtighten, as this
might damage the rubber seal.
Using the compass.
1.
Invert the flashlight, holding the compass
upright. Wait a moment while the compass stops
moving.
2.
The compass will orient itself to the
magnetic directions. N toward the North, S toward
the South, etc.
3.
There are many uses for a compass. For
example by taking bearings as you move away
from a starting point, you may be able to find your
way back by reversing those directions on the
return trip. Or you can find landmarks on a map
by orienting yourself with the compass.
SKU 92061 DowFnlooardtferocmhWniwcwa.lSqomuaensutailos.ncosm,.pAllel MaasneuaclsaSlle1a-rc8h0A0n-d44D4ow-3nl3o5ad3. Page 6
|