35 MM OUTDOOR CAMERA
90850
OPERATING INSTRUCTIONS
®
3491 Mission Oaks Blvd., Camarillo, CA 93011
Copyright © 2003 by Harbor Freight Tools®. All rights reserved. No portion of this
manual or any artwork contained herein may be reproduced in any shape or
form without the express written consent of Harbor Freight Tools.
For technical questions and replacement parts, please call 1-800-444-3353
Operation
Loading the Camera
Note: Load and unload the film only in low light or shade. Bright light can damage the film
whether it is exposed or unexposed.
1.
2.
Open the back of the Camera by pushing down on the latch on the left side of the back
cover. Put the roll of film (not included) in the slot on the left side of the Camera.
Stretch the film over to the take-up spool making sure that the sprocket holes on the
film fit onto the teeth across the bottom/middle of the Camera. Insert the end of the
film through the slot on the take-up spool.
See FIGURE 1.
3.
Wind the film by turning the center Knob from left to right slightly, to make sure that it
catches, then close the back of the Camera. Wind, using the center Knob until it stops,
and click the Trigger Button. Repeat 2-3 times until the film is past the exposed portion.
Shooting the Camera
1.
Turn the center Knob from left to right until it stops. Hold the Camera steady (using
both hands) making sure your finger is not in front of the lens.
Look through the Viewfinder and center your object. Gently push the Trigger Button.
See FIGURE 1.
2.
Unloading the film (not included)
Note: When the counter on the bottom of the Camera indicates you have shot your last
picture, you must rewind the film before opening the Camera or you will expose and
ruin the film.
1.
Unlock the film release by pushing and holding in the button on the bottom of the
Camera, under the Knob. Flip the Handle up on the Rewind Dial and turn it clockwise
(as indicated on the dial) until you hear and feel that the entire roll is back in side the
film cartridge (Approximately 60 turns). See FIGURE 1.
2.
Open the back of the Camera by pushing down on the latch on the left side of the back
cover. Unload the Camera.
FIGURE 1
Trigger
Button
Rewind Handle
Viewfinder
Lens
(Inside)
Take-up
Spool
Teeth
Film Release Button
Knob
Loading Slot
Page 3
SKU 90850
|