Grizzly Saw H7777 User Manual

MODEL H7777  
8" STACK DADO SET  
INSTRUCTION SHEET  
Read and understand your table saw manual, set up your table saw according to the manual,  
then use your table saw enough to be familiar with it before attempting dado cuts. Making dado  
cuts is one of the more difficult operations that can be performed on a table saw. The size of the  
cut increases the chances of kickback. Kickback happens when the workpiece is thrown towards  
the operator at a high rate of speed. Until you have a clear understanding of kickback and how  
it occurs, DO NOT use this dado set! We strongly recommend that you read books, trade maga-  
zines, or get formal training before using this dado set. Failure to follow these warnings could  
result in serious personal injury. Regardless of the content in this instruction sheet, Grizzly  
Industrial will not be held liable for accidents caused by lack of training.  
Inventory (Figure 1)  
Right Outside Blade .......................................... 1  
Qty  
Introduction  
The outside blades of this 30 tooth dado set fea-  
ture five sets of teeth. Each of these sets consist  
of five angled teeth and a flat tooth. The angled  
teeth shown in Figure 2 cut the wood fibers  
cleanly to prevent splintering and chipping at the  
edge of the dado and the flat teeth cut the flat bot-  
tom of the dado. Cutting a dado requires at least a  
1½ HP table saw. Do not use this set in a portable  
table saw, a miter saw, or a circular saw.  
Left Outside Blade............................................. 1  
1
8" Chip Cutters ................................................. 4  
332" Chip Cutter.................................................. 1  
116" Chip Cutter.................................................. 1  
0.005" Shims ..................................................... 2  
0.010" Shims ..................................................... 2  
0.015" Shims ..................................................... 2  
0.020" Shims ..................................................... 2  
Set-Up  
To install dado blades, do these steps:  
1. UNPLUG THE TABLE SAW!  
2. Remove the blade guard and anti-kickback  
devices, the table insert, the arbor nut and  
arbor flange, and the table saw blade.  
Figure 1. Inventory.  
COPYRIGHT © AUGUST, 2005 BY GRIZZLY INDUSTRIAL, INC.  
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE  
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.  
#EW7524 PRINTED IN CHINA  
 

Greenheck Fan Nail Gun QEI User Manual
Hamilton Beach Blender Immersion Mixer User Manual
HANNspree Computer Monitor HF235 User Manual
Hans Grohe Indoor Furnishings Axor Citterio User Manual
Harbor Freight Tools Sander 96445 User Manual
Havis Shields Automobile Accessories C TSM CHGR D User Manual
Honeywell Air Conditioner HZ 614 User Manual
HP Hewlett Packard Network Router CFL 512 User Manual
Hustler Turf Mobility Aid Z User Manual
Impex Fitness Equipment SAG 51 User Manual