MODEL G4570
ACCU-SHARP®
GRINDING JIG
INSTRUCTIONS
To reduce the risk of serious injury when
using this grinding jig, take the following
precautions:
1. GRINDER OWNER'S MANUAL. read
and understand the owner's manual for
your grinder and always follow all of the
safety precautions and instructions for
your grinder.
2. EyE/fACE PROTECTION. always wear
safety glasses or a face shield to protect
yourself from flying material.
figure 1. using the accu-sharp Jig to grind the
bevel of a flat chisel.
3. HAND PLACEMENT. always keep your
hands and fingers away from the spinning
grinding wheel, and protect yourself from
the sharp edges of the tool.
Inventory
after removing the contents of the shipping pack-
age, lay them out and refer to figure 2 to inven-
tory the components.
4. SECURE CLAMPING. Make sure the tool
is securely clamped in the jig and that the
table is firmly locked in the proper posi-
tion.
tool
Clamping
Jig
auxiliary
table
Introduction
the Model g4570 accu-sharp® grinding Jig
works with the tool rest table of your grinder, such
as the grizzly Model g1036 slow speed grinder,
to properly position chisels and plane irons up to
23⁄4" wide, as shown in figure 1. the tool clamp-
ing jig uses a special plastic rod and pads to slide
the tool from side-to-side across the auxiliary
table and the grinding wheel.
Mounting
screws
figure 2. Model g4570 inventory.
If you need help with your new grinding jig, call
our Tech Support at: (570) 546-9663.
Copyright © NoVEMBEr, 2008 By grizzly iNdustrial, iNC.
WARNING: NO PORTION Of THIS MANUAL MAy bE REPRODUCED IN ANy SHAPE
OR fORM WITHOUT THE WRITTEN APPROvAL Of GRIzzLy INDUSTRIAL, INC.
#ts11341 priNtEd iN ChiNa
|