MODEL H2881
4" PNEUMATIC DRUM
SANDER
INSTRUCTION SHEET
EYE/EAR INJURY HAZARD!
Wear safety glasses and
hearing protection during
use of this tool!
OVER INFLATION HAZARD!
Never exceed 8 PSI!
RESPIRATORY HAZARD!
Sanding produces fine
dust. Wear the appropriate
protection during use!
Figure 1. Model H2881.
Introduction
This rolling-pin style pneumatic drum sander
is perfect for hand contouring and smoothing
projects that are too large to use with a station-
3
ary sander. Simply chuck the ⁄8" spindle into a
portable electric drill, cordless drill or air powered
1
drill for two-handed control. Choose this 4" x 1 ⁄8
"
diameter size for getting into tight areas. Features
ball bearing handle and air valve for easy bicycle
pump inflation.
Figure 2. Pneumatic drum sander in action.
Inventory
4" Aluminum Oxide Sanding Sleeves
A. Drum Sander.............................................. 1
B. Spare Valve Cap........................................ 1
1
H3875 1 ⁄8" x 4" x 60 Grit
1
H3876 1 ⁄8" x 4" x 100 Grit
1
H3877 1 ⁄8" x 4" x 150 Grit
Operation
1
H3878 1 ⁄8" x 4" x 180 Grit
1
Slide the sanding sleeve over the drum. Remove
the plastic cap on the handle with a small screw
driver to expose the air valve. Inflate to the desired
pressure. DO NOT exceed 8 PSI!
H3879 1 ⁄8" x 4" x 220 Grit
1
H3880 1 ⁄8" x 4" x 320 Grit
If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.
COPYRIGHT © MARCH, 2006 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#PC8119 PRINTED IN TAIWAN
|