MODEL G1600
PNEUMATIC SANDING
DRUM FOR MODEL G1495
INSTRUCTIONS
Specifications
Mounting Bore..............................1" x 12 TPI LH
Length...............................................................6"
Diameter...........................................................4"
Air Inlet Type ...............................Schrader Valve
Maximum Pressure .................................. 10 PSI
Inflation Method.................... Manual Pump Only
EYE INJURY HAZARD!
Always wear safety glasses
during use to prevent
serious personal injury.
10 PSI MAX
AIR PRESSURE!
Exceeding this PSI may
result in injury/tool damage.
Inventory
A. Pneumatic Sanding Drum .......................... 1
B. Sanding Sleeve .......................................... 1
RESPIRATORY HAZARD!
Sanding produces fine
dust. Wear the appropriate
protection during use!
Functional Overview
A pneumatic sanding drum mounted to a lathe
allows for easy and smooth sanding of contours
and curves.
A
B
The inflatable bladder provides for easy changes
of the replaceable sanding sleeve and also allows
for fine-tuning of the overall flexibility of the drum
for sanding compound curves and contoured sur-
faces.
Figure 1. Model G1600.
By increasing the pressure in the drum, a user
can create a more rigid surface for sanding shal-
low contours. Similarly, by decreasing the pres-
sure, a user can soften the surface of the drum,
allowing it to "wrap-around" workpieces with
tighter curves.
Replacement Sanding Sleeves
G4387 4" x 6" x 60 Grit Silicon Carbide
G4388 4" x 6" x 80 Grit Silicon Carbide
G1975 4" x 6" x 100 Grit Silicon Carbide
G4389 4" x 6" x 120 Grit Silicon Carbide
G1976 4" x 6" x 150 Grit Silicon Carbide
Completely releasing the pressure decreases the
diameter of the drum so the sanding sleeve can
be removed and replaced.
COPYRIGHT © MARCH, 2008 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#JB10532 PRINTED IN TAIWAN
|