Graco Digital Camera 241123 User Manual

INSTRUCTIONS–PARTS LIST  
308924  
Rev. B  
This manual contains important  
warnings and information.  
READ AND KEEP FOR REFERENCE.  
First choice when  
quality counts.t  
INSTRUCTIONS  
GTS-4900 HVLP  
2-Speed Turbine Conversion Kit (120V)  
Model 241123, Series A  
2-Speed Turbine Conversion Kit for 120V GTS-4900 Four-Stage HVLP Turbine Sprayer  
8 psi (55 kPa, 0.5 bar) Maximum Working Pressure  
Related Manual  
HVLP Turbine Sprayers . . . . . . 308808  
7943B  
GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440–1441  
ECOPYRIGHT 1999, GRACO INC.  
Graco Inc. is registered to I.S. EN ISO 9001  
 
Turbine Kit Installation  
One- and two-digit numbers  
(in parentheses) refer to parts  
as they are called out in  
manual 308808. Three-digit  
numbers refer to new kit parts.  
(1)  
104 (25)  
108 (82)  
102 (24)  
(6)  
109 (83)  
106 (19)  
(18)  
(23)  
(5)  
105 (41)  
103 (42)  
(48)  
107 (31)  
(34)  
(33)  
(2)  
(7)  
(27)  
7943B  
Fig. 3  
4. Remove turbine gasket (25), three screws (6),  
turbine plate (82), and three turbine spacers (83).  
7. Remove rocker switch (31) and wires connected to  
it (Fig. 4 wiring diagram).  
NOTE: Steps 5 and 8 apply only if your GTS-4900  
turbine sprayer has a speed controller (48). Installation  
of this 2-Speed Turbine Conversion Kit does not  
include reconnecting wires to the speed controller.  
The speed controller is no longer used with the  
2-speed turbine.  
8. Remove two remaining wires connecting speed  
controller (48) to red rocker switch (34) and filter  
indicator light (33).  
Rocker Switch Installation and Wiring  
See Wiring Diagram in Fig. 4.  
1. In orientation shown in Fig. 3, install rocker switch  
(107) in hole left by removed switch (31).  
5. Remove turbine motor wires from spade terminals  
on speed controller (48).  
2. Connect male tab end of one white wire (110) to  
spade terminal 2 of switch (107). Position spade to  
outside of switch to ease connection of second  
wire. Connect other end of white wire to spade  
terminal 5 of red rocker switch (34).  
6. Rotate turbine (24) from outlet fitting (18) and lift  
up from turbine spacers (23) and turbine duct (5)  
to remove.  
308924  
3
 
Turbine Kit Installation  
3. Connect male tab end of second white wire (110)  
Turbine Reassembly  
to spade terminal 1 of switch (107), and connect  
other end to spade terminal 6.  
1. Install turbine by rotating into outlet fitting (18)  
using o-ring packing (106) and positioning on  
spacers (23) in turbine base plate.  
4. Connect male tab end of black wire (111) to spade  
terminal 2 on the red rocker switch (34). Connect  
other end to open spade terminal on filter indicator  
light (33).  
2. Install 3 spacers (109). Reconnect ground wire  
ring terminal to closest spacer (109). Check that  
no wires are pinched by hardware.  
Installation and Wiring of 2-Speed Turbine  
3. Mount turbine plate (108) on spacers (109) with  
screws (6).  
1. Fig. 3. Replace turbine gaskets (41 and 42) with  
gaskets (105 and 103) on turbine duct (5).  
4. Install turbine gasket (104).  
5. Reassemble turbine.  
2. Place 2-speed turbine (102) alongside turbine  
base plate (2), standing it on end (large-diameter  
end up).  
3. Connect black wire from turbine to spade terminal  
wire connected to terminal 2 of red rocker  
switch (34).  
4. Connect white wire from turbine to spade terminal  
5 of rocker switch (107).  
5. Connect yellow wire from turbine to spade terminal  
wire connected to terminal 1 of rocker  
switch (107).  
Motor  
Y
BE  
R
BK  
W
6. Connect blue wire from turbine to spade terminal 4  
of rocker switch (107).  
G
7. Connect red wire from turbine to spade terminal  
wire connected to terminal 2 of rocker  
switch (107).  
2-Speed Turbine  
Wiring Diagram  
7244B  
Fig. 4  
Kit Parts  
Ref  
Ref  
No. Part No. Description  
Qty  
No. Part No. Description  
Qty  
102 114650 TURBINE, 4-stage, 2-speed; 120V  
103 192846 GASKET, duct  
104 192788 GASKET, turbine  
105 192845 GASKET, duct  
1
1
1
1
1
107 114658 SWITCH, rocker  
108 194094 PLATE, turbine  
109 194097 SPACER, turbine  
110 240927 CONDUCTOR, electrical, white  
111 240257 CONDUCTOR, electrical, black  
1
1
3
2
1
106 156698 PACKING, o-ring  
All written and visual data contained in this document reflect the latest product information available at the time of publication.  
Graco reserves the right to make changes at any time without notice.  
Sales Offices: Minneapolis, Detroit  
Foreign Offices: Belgium, Korea, Hong Kong, Japan  
GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 554401441  
PRINTED IN USA 308924 01/1999, Revised 02/2000  
308924  
4
 
 

Grandstream Networks IP Phone GXV3175 User Manual
Haier Air Conditioner 001051 User Manual
HANNspree Flat Panel Television ST03 15H1 User Manual
Hasbro Board Games LR6 User Manual
Havis Shields Indoor Furnishings KR 9 0 FX User Manual
Hearth and Home Technologies Indoor Fireplace 8000CFLP OAKIPI User Manual
Honeywell Thermostat 7300 User Manual
HP Hewlett Packard Scanner 7400c User Manual
Husqvarna Brush Cutter 345FR User Manual
IBM Switch 1X8 User Manual