Graco Crib 9120 User Manual

Your Pack ’N Play® may be used as a playard or po  
instructions in this manual and those found on the  
spend reading the instructions and warnings will h  
Read all instructions BEFORE  
assembly and use of this product.  
Keep instructions for future use.  
We recommend that you keep these instructions  
with your Pack ’N Play. A storage pocket has been  
provided for them on the bottom panel of your unit.  
Failure to follow  
instructions cou  
Setting Up the Pack ’N Play  
!
THIS PRODUCT REQUIRES ADULT ASSEMBLY.  
!
Keep fingers clear of top corners during setup.  
®
Be sure Pack ’N Play is completely set up before use.  
Check that the four top rails are completely latched, the  
center of the floor is pushed down, and the mattress is  
flat and secured by the VELCRO® straps. Always follow  
the instructions in the owner’s manual to set up the  
Pack ’N Play.  
Pack ’N Play  
OWNER’S  
MANUAL  
!
Before each use, inspect this product for damaged  
hardware, loose joints, missing parts or sharp edges.  
Do not use Pack ’N Play if any parts are missing  
or broken.  
Call 1-800-345-4109 for replacement parts or owner’s  
manual. Do not substitute parts.  
Model No. _________  
Serial No. _________  
Using the Pack ’N Play  
!
The Pack ’N Play can be used as a playard or a  
Dear Customer,  
sleeping crib. When used as a playard, never leave  
child unattended and always keep child in view.  
When used as a sleeping crib, you must still provide  
the supervision necessary for the continued safety of  
your child.  
Please fill in the model and serial numbers  
above from the label on the center of the  
bottom of your new Pack ’N Play.  
Model Nos. 9120, 9122, 9125,  
9126, 9130, 9131, 9132 & 9135  
!
Always keep the Pack ’N Play away from hazards in the  
area that may injure your child.  
!
Do not add padding or other objects inside the Pack ’N  
Play that will permit your child to climb out.  
Congratulations on your purchase of a  
Graco® Pack ’N Play®!  
!
Stop using this product when your child reaches  
35 inches (89 cm) in height, weighs more than 30  
pounds (14 kg), or is able to climb out.  
Graco is the recognized leader in the  
design and manufacture of quality baby  
products. We believe your new Graco®  
Pack ’N Play® is a wise choice, promising  
many hours of enjoyment for your baby.  
!
Do not modify Pack ’N Play or add any attachments  
that are not listed in the owner’s manual, including an  
add-on bassinet.  
Customer Satisfaction  
Avoiding Suffocation Hazards  
Our goal is to make every product the best it  
can be! We are also committed to supporting our  
products after purchase. If you would like to speak  
to Graco about your product, please contact our  
Customer Service Department at 1-800-345-4109  
Our knowledgeable staff will be ready to answer  
any questions you may have concerning parts, use  
or maintenance. When you call, please have the  
model and serial numbers ready so your call  
may be processed quickly and efficiently.  
!
Unlike cribs that have rigid sides, the Pack ’N Play has  
flexible sides. As a result, the Pack ’N Play mattress is  
specially designed to prevent suffocation.  
The Pack ’N Play mattress has a solid base, a certain  
Failure to  
instructions cou  
© 1999 Graco 363-7-99  
2
 
At first your Pack ’N Play may  
be like a new pair of shoes.  
You may need to break it in by  
slightly stretching the netting  
and fabric. If the center does not  
stay down, place some weight  
(several books) in the center of  
the unit and let it stand  
To Use Your Changing Table  
(on certain models)  
Parts List  
CHECK that you have all parts listed below  
BEFORE assembling your changing table.  
overnight.  
No tools required.  
Step 5.  
Long tube (2)  
Short tube (2)  
Place the mattress into your  
unit with padded side up.  
Always use your unit with  
mattress installed soft side up.  
Slide the two VELCRO® straps  
through slots in bottom of Pack  
’N Play and fasten to VELCRO®  
on underside. This will prevent  
mattress from moving.  
Your Pack ’N Play is ready to  
use.  
Changing pad  
Changing  
table  
Accessory bag  
Side Flap  
(on certain models)  
You can raise side flap if  
desired.  
To protect your child from falls and other injuries:  
• Always stay within arm’s reach of your child when  
using the changing table. Always use waist belt when  
child is on the changing table. Never leave child  
unattended.  
Unfasten VELCRO® straps at  
bottom of flap. Roll flap up.  
Fasten in place with snap loops  
at top.  
• The changing table is designed for use only with this  
Graco Pack ’N Play. Do not attempt to use it with any  
other product. Before each use, make sure the  
changing table is properly secured to the Pack ’N Play  
by pushing down firmly in the middle of the changing  
table. The changing table should not fall.  
Toy Bag  
(on certain models)  
• Do not use the changing table as a sleeping or play  
area.  
Toy bag snaps on end of  
unit. Maximum weight 2 lbs  
(0.9 kg).  
• Weight limit for the changing table is 25 pounds  
(11 kg). Do not use the changing table as extra  
storage. Always remove the changing table when  
your child is in the Pack ’N Play.  
DO NOT machine wash or dry  
in a dryer. DO NOT dry clean.  
Spot clean with a damp cloth  
and a mild detergent. NO  
BLEACH.  
• The Pack ’N Play changing table can be used on the  
floor without being attached to the Pack ’N Play.  
Never place the changing table on a piece of furniture,  
bed, counter or any raised surface from which the  
changing table or your child could fall.  
363-7-99  
5
6
 
Step 1.  
Step 5.  
Lay changing table flat on floor with short side in front  
of you and belt facing up. Gently slide one long tube into  
opening on long side exactly as shown.  
Now repeat steps  
2, 3 and 4 on how to  
install the short tube  
on the other end of  
the changing table.  
Long  
Repeat on other long side.  
side  
If the short tubes  
have been inserted  
correctly, the  
Fold up  
changing table should  
be able to FOLD UP in  
the center as shown.  
If you cannot fold the  
tubes up in the center,  
review steps 2, 3, and 4.  
Short side  
Step 2.  
Step 6.  
Slide one short tube  
into opening on end  
as shown.  
Place pad in changing  
table with vinyl side up.  
Pull belt straps through  
holes in center of pad.  
Be sure folding side of  
hinge faces pad as  
shown.  
Fold side  
of hinge  
DO NOT insert other  
short tube at this time.  
Step 7.  
Step 3.  
Insert VELCRO® straps  
into the four slots at  
the corners of changing  
table and attach to  
VELCRO® on underside  
of changing table. This  
will prevent pad from  
moving.  
Turn up long tube so  
that its end points down.  
Insert end of long tube  
into opening on end of  
short tube as shown.  
DO NOT slide short  
tube up around the bend  
of long tube until you  
have finished next step.  
Short tube side  
Step 8.  
Make sure fabric does not get caught in opening when  
inserting long tube into short tube.  
Place changing table on  
Pack ’N Play as shown.  
Make sure tubes are  
placed securely over  
the sides of the  
Step 4.  
Pack ’N Play®.  
Repeat step 3 on other  
end of short tube, then  
slide short tube ends  
up onto long tubes.  
Check that the  
changing table is  
properly supported by the  
Pack ’N Play® by pushing  
firmly down into center of  
changing table.  
TO AVOID TEARING  
FABRIC, slide the  
short end up before  
proceeding with  
step 5.  
Slide ends up  
7
8
 
Step 2.  
To Fold Changing Table  
IMPORTANT: Raise center  
halfway BEFORE unlocking  
rails.  
Step 1.  
Pull up on waist belt  
straps to fold.  
Grasp center loop as shown  
and pull up approximately  
halfway to the top rails.  
Step 2.  
Ends of long tubes  
must point up when  
folded as shown.  
Step 3.  
The top rail has a center piece  
with two tubes hidden under the  
fabric. The button on the bottom  
of the center piece releases the  
two tubes when it is pushed up.  
Center  
piece  
Step 3.  
To carry or store your changing table with your folded  
Pack ’N Play, see “To Cover Your Pack ’N Play” section  
in these instructions.  
Tube  
Push UP button  
under fabric  
To Use Accessory Bag  
(on certain models)  
Snap accessory bag  
onto end of Pack ’N Play  
with four snaps as shown.  
To fold the top rail:  
!
Lift up slightly on the top rail.  
!
Push up on the button located under the symbol  
!
to release the two tubes.  
!
Push down.  
!
If top rails do not unlatch, lift  
the center of the floor higher.  
!
!
Both tubes must be released  
for the top rail to fold.  
®
To Fold Your Pack ’N Play  
!
Step 1.  
Release the two VELCRO® straps  
under the Pack ’N Play, and  
remove the mattress.  
Step 4.  
Pull center up all the way.  
363-7-99  
9
10  
 
Step 5.  
Replacement Parts  
Gather your unit together.  
Do not force.  
Instructions for ordering Pack ’N Play® parts:  
Complete form below. Your Pack ’N Play model number  
MUST be included on the form to ensure proper  
replacement parts. Your model number can be found  
on a label on the center of the bottom of the unit.  
Payment must accompany your order.  
If unit will not fold, look for  
a partially latched top rail.  
Squeeze the latch button to  
release the rail.  
Parts List:  
Price:**  
Mattress .....................$19.00  
Carry bag ...................$13.00  
Changing table parts:  
Step 6.  
Find the bottom corner belt loop  
(only one). This loop is for holding  
unit and mattress together while  
carrying.  
Long tube* ..................$ 9.00  
Short tube* .................$ 7.00  
Changing pad* ...........$10.00  
Changing table* ......... $15.00  
Accessory bag* ..........$ 7.00  
Toy bag* ......................$13.00  
Fitted sheet..................$..10.00  
* On certain models  
** Prices subject to change without notice.  
Step 7.  
Wrap the mattress around your  
unit. Fasten together the VELCRO®  
straps, attaching the bottom strap  
to the bottom corner belt loop.  
IF YOU NEED HELP  
If you have any questions or if you need  
any part not listed, please call toll-free:  
1-800-345-4109  
Return the form below with payment to:  
GRACO CHILDREN’S PRODUCTS INC.  
CUSTOMER SERVICE DEPARTMENT  
P.O. BOX 100, MAIN STREET  
®
To Cover Your Pack ’N Play  
ELVERSON, PA 19520  
Step 1.  
Model Number SHIP TO:  
Pull cover over your unit. Be sure  
the carrying handle attached to the  
Pack ’N Play mattress is exposed.  
(Must be filled in)  
Name  
Mattress  
Carry bag  
Long tube  
Certain models have a second  
handle on the carrying bag.  
Address  
Short tube  
Changing pad  
Changing table  
Accessory bag  
Toy bag  
City, State, Zip  
Step 2.  
(
)
Zip together.  
Telephone  
Fitted sheet  
On changing table models, turn unit  
upside down so that feet point up.  
Pull the cover over your unit. Turn  
unit over.  
Check enclosed  
(payable to Graco Children’s  
Products Inc.)  
Charge to credit card:  
Visa  
MasterCard  
Discover  
Before pulling bag up, insert folded  
changing table into the side oppo-  
site the handle as shown. Pull bag  
up to cover end. Zip together.  
Total:  
Shipping  
& handling:  
$5.00 Account #:  
6% sales tax  
(PA only):  
Expiration date:  
Signature:  
Total amount  
due:  
11  
12  
 

Graco High Chair 3625 User Manual
Greenheck Fan Smoke Alarm SEFSDR 511 User Manual
Guardian Technologies Portable Generator 5209 User Manual
Haier Refrigerator PRTS User Manual
Honeywell Battery Charger 8x User Manual
Honeywell Laptop 6100 Mobile Computer User Manual
Honeywell Thermostat CT3200 User Manual
HP Hewlett Packard All in One Printer Q3701 User Manual
IDEAL INDUSTRIES Power Hammer 61 095 User Manual
iHome Clock IP38 User Manual