GE Monogram Trash Compactor ZCG3100VBB User Manual

ZCG3100VBB – GE Monogram Built-In Compactor  
Dimensions and Specifications (in inches)  
This Monogram compactor has a white control  
Additional Specifications  
panel and is supplied with a white/black reversible A 115 Volt, 60 Hz. power supply is required. An individual properly grounded  
aluminum front drawer panel. This panel can be  
reversed to reveal the opposite color side.  
branch circuit protected by a 15- or 20-amp circuit breaker or time delay fuse  
is recommended. Install a properly grounded 3-prong electrical receptacle  
recessed into the back wall. Electrical outlet location is critical for proper cord  
storage when compactor is installed.  
34"-35"  
12-1/8"  
min.  
The design will accept a custom front drawer panel  
to match surrounding cabinetry. A 1/4"-thick panel  
can replace the aluminum panel and will slide into  
the existing trim on the drawer front. A 3/4"-thick  
20-1/4"  
If the compactor is to be located in or near a corner of base cabinets, allow  
2" minimum clearance from the corner to prevent interference with adjacent  
panel can replace the aluminum panel and existing door handles.  
34"  
min.  
adj. to  
35"  
trim for a trimless appearance.  
Note:  
22-1/2" min.*  
The adjustable base allows the toekick depth to  
match surrounding cabinetry. This compactor is  
designed as a built-in appliance only. It may be  
located in any convenient space under a countertop.  
DO NOT OPERATE FREE-STANDING because the  
compactor will tip over when the drawer is  
pulled out.  
If cord is to be plugged in directly behind compactor add 2-1/2" to overall  
depth in order to allow proper clearance for the electrical cord.  
max.  
*Add 2-1/2" to  
depth if outlet  
is located directly  
behind compactor  
12"  
Adjustable base  
2-3/4" to 4-1/4"  
Custom Panel Dimensions  
The drawer panel size varies depending on applcation.  
1/4"-Thick Custom Panel  
Cut the panel to size and install.  
3/4"-Thick Custom Panel  
3/4" Custom  
The custom panel should be constructed in the  
same manner as typical cabinet doors. Cut edges  
must be finished on all sides.  
Drawer  
Panel With  
Custom  
1/4" Custom  
Drawer  
Panel  
3/4" Custom  
Drawer  
Panel  
24-3/4"  
24-1/2"  
25-13/16"  
Handles  
Listed by  
Underwriters  
Laboratories  
3/4"-Thick Custom Panel with Custom Handle  
The supplied handle may be replaced with a  
custom handle of your choice.  
R
12"  
11-11/16"  
12"  
®
For answers to your Monogram, GE Profile or  
®
GE appliance questions, visit our website at  
®
GEAppliances.com or call GE Answer Center  
Specification Revised 9/03  
service, 800.626.2000.  
160001  
 

Crown Audio Microphone PCC 170 User Manual
Cuisinart Coffeemaker DCC 900C User Manual
Cuisinart Coffeemaker PG 30765 User Manual
Curtis Clock Radio KCR2607 User Manual
Cypress Computer Hardware CY7C65113C User Manual
EVGA Computer Hardware 141 LF E658 User Manual
Field Controls Oxygen Equipment FDVS User Manual
Foster Refrigerator HR120 LR120 User Manual
Garland Gas Heater BCO G 10 User Manual
GE Double Oven jk910 User Manual