EdgeStar Fan EAC420 User Manual

 
5. DO NOT attempt to repair or adjust any electrical or  
mechanical functions on this unit as this may void the  
warranty.  
6. Check the household voltage to ensure it matches the  
appliance’s rate specification.  
MAINTENANCE  
Before you clean the appliance, switch it off, remove the  
plug from the power socket and wait until the product has  
cooled down.  
Use a damp cloth to clean the product housing.  
Do not use water, detergents, abrasive cleaning liquids or  
chemical agents (e.g., Alcohol, Gasoline etc…) to clean the  
appliance.  
7. DO NOT cover the air inlet or outlet.  
8. Always unplug the product before refilling the water tank.  
9. Always unplug the product when not in use. To disconnect  
from the power supply, grip the plug and pull it from the  
power socket. Never pull by the plug out by the cord.  
10.This product is not intended for use in wet or damp  
locations. Never locate the product where it may fall into a  
bathtub or other water container. DO NOT use in  
bathrooms or outdoors. When not in use always store in a  
dry area.  
Store the unit in its original packaging in a dry, dust free  
area during the off season.  
11.DO NOT run the power cord under carpeting or cover with  
rugs or runners. Keep the cord away from areas where it  
may be tripped over.  
12.Avoid the use of an extension cord.  
13.DO NOT insert or allow objects to enter any ventilation or  
exhaust opening as this may damage the product and  
could cause an electrical shock or fire.  
14.DO NOT use the product in areas near gasoline, paint, or  
other inflammable goods or objects.  
15.If the supply cord is damaged it must be replaced by the  
manufacturer or an authorized service center.  
16.Unplug or disconnect the appliance from the power before  
servicing and cleaning.  
2
7
 
TIMER OPERATION  
SPECIFICATIONS  
The TIMER can be used to switch the product off after a  
selected number of hours.  
Turn the unit on.  
Select the desired operating mode, speed, etc.  
Press the TIMER button once and the product will switch  
off after 1 hour. Press the button again for 2 hours, again for  
3 hours etc. The maximum timer setting is 8 hours. The LED  
display will show the number of hours the timer is currently set  
for.  
Model No. EAC420  
Voltage  
Frequency 60Hz  
Wattage 250W  
120V  
Net Weight 23 pounds  
PARTS DESCRIPTION  
To cancel the Timer setting press the TIMER button again  
until all the timer indicators are dark.  
REMOTE OPERATION  
POWER: This button  
turns the unit ON or OFF.  
MODE: This button turns  
the COOL MODE on or  
off.  
SPEED: This button  
toggles through the fan  
speeds  
TIMER: This button  
controls the TIMER  
SWING: This button  
adjusts the louver swing.  
1 Top cover  
2 Handle  
3 Horizontal louvers  
4 Left side  
9
Air vent  
10 Front cover  
11 Water level  
12 Remote control  
a) To replace the batteries, remove the cover of the battery  
compartment. Install two AAA 1.5V Batteries, and then  
replace the cover.  
b) The effective operating range of the remote control is  
about 13 feet in front of the unit and about 10 feet on the  
side.  
5 Front cover ornament 13 Remote control holder  
6 Power cord hole  
7 Caster wheels  
8 Top cover lid  
14 Right side  
15 Water inlet panel  
16 Drain  
c) Take out the batteries if the remote will not be used for a  
long period.  
d) Replace the batteries as soon as the remote control does  
not work normally.  
e) Do not allow children to use the remote as a toy.  
6
3
 
CONTROL PANEL  
Press the MODE button to select the COOL MODE, as  
indicated by the LED. The full effect of this mode will  
begin to be felt after about 3 minutes.  
Once all the water in the tank has been used turn the  
product OFF, unplug it from the electrical socket, and refill  
the tank.  
To turn the product OFF press the POWER button again.  
If you do not intend to use the product again for some time  
empty the water tank.  
To empty the water tank, turn the unit off using the  
POWER button. Unplug the unit from the power outlet.  
Remove the drain cap from the drain and allow the water  
to drain out.  
HUMIDIFICATION CONTROL  
OPERATING INSTRUCTIONS  
Choose a suitable location for your unit; as noted in the  
first section, the unit will produce greater cooling when  
located in an area in which air can “flow through.”  
This unit can be operated by the controls on the control  
panel or with the remote control  
COOLING OPERATION  
Remove the plug from the electrical socket.  
Open the top cover lid or water inlet panel and pour clean  
water into tank. The water inlet panel will allow you to pour  
more water in, faster. Additionally, some ice cubes will  
increase the cooling performance. Then connect to the  
power supply.  
Open the top cover lid  
Turn the dial counter-clockwise for maximum  
humidification.  
Turn the dial clockwise for minimum humidification.  
Press the POWER button to turn the unit on. The fan will  
start at MEDIUM speed, and after few seconds it will  
switch to LOW speed.  
Press the SPEED button to increase or decrease the  
speed.  
LOUVER CONTROL  
Press the SWING button to start the vertical louvers  
automatically moving from side to side. To stop the louvers  
press the SWING button again.  
You can change the air direction up or down by manually  
4
adjusting the horizontal louvers.  
5
 

Compaq Network Card G200 User Manual
Cosco Safety Gate SLC User Manual
Craftsman Cordless Saw 13721241 User Manual
Crown Audio Music Mixer 160MA User Manual
Electro Voice Portable Speaker 1 Series II User Manual
Extron electronic Switch XTP T UWP 302 User Manual
Fisher Price Video Games T6356 User Manual
Frigidaire Refrigerator FFTR1814B User Manual
GE Answering Machine 00023598 User Manual
Generac Spreader 1403 0 User Manual