Printed in Japan 2006/12 284-8050-02
CCD Camera Power Supply Box
4. Mounting Procedure
CAA-185-200
Installation Instructions
Mounting the CCD Camera Power Supply Box
Mount the CCD camera power supply box in a location such as under a seat using either the
supplied tapping screws (ø4 x 12) or velcro.
1. Precautions
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules.
■ Mounting Using Tapping Screws
■ Mounting Using Velcro
CCD camera
power supply box
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
ø4■12
CCD camera
power supply box
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to consult the dealer or an experienced radio/TV technician
for help.
ø4■12
INFORMATION FOR USERS:.
Velcro
CHANGES OR MODIFICATIONSTO THIS PRODUCT NOT APPROVED BY THE MANUFACTURER WILL
VOID THE WARRANTY AND WILL VIOLATE FCC APPROVAL.
* Thoroughly wipe any dirt from the mounting
surface.
* Remove the separator from the back of the
velcro and apply it to the mounting surface.
2. Package Contents
1. CCD camera power supply box: ·············1 4. Bag of accessories: ················· 1 bag
Fig.3
Fig.4
Connector cable (red): ······························ 1
2. Bag of accessories: ················· 1 bag
Connector cable (light green): ·················· 1
Electro taps:·············································· 2
Velcro: ······················································· 1
Velcro: ······················································· 1
Connector cable (black): ··························· 1
Connector cable (red): ······························ 1
CAUTION
1. If harnesses will come into contact with the sharp edges of metal plates, or the like, protect
them using grommets or insulation tubes.
5. RCA cable ········································ 1
3. Bag of accessories: ················· 1 bag
Tapping screws: ········································ 2
2. Before drilling any holes in a vehicle, make sure that there are no electrical wires, brake fluid
pipes, or the like, running behind to surface to be drilled.
3. Making Connections
3-1. System Connection Example
CCD camera
power supply box
CCD camera
Light green
GND
Black
Red
To reverse gear
signal (12 V)
To ACC power supply (12 V)
For making connections to a TV
or video monitor equipped
with a video input jack
Fig.1
3-2. Connecting the Supplied Cables
Hook up the supplied connector cables as shown in Fig. 2.
Light
green
Black
Red
To reverse gear signal (12 V)
GND
To ACC power supply (12 V)
Used to provide a 12 V power supply
to an additional device.
FIG.2
3-3. Power Cable Connections
When connection cannot be made to the terminals, use the supplied Electro Tap to make
the connection as illustrated in the diagram.
As illustrated in the diagram, the intermediate
cable is brought against the stopper and bent
back in the direction of the arrow.
The tip of the cable is
cut at a convenient
length.
Not needed
From the vehicle side
Power cable
Latch
Coupler connected
to another piece of
equipment
From the unit
Stopper
From the unit
Pass the vehicle-side cable through and
bend back in the direction of the arrow.
Power cable
Hook
Vehicle-side wire
Close with pliers until the latch engages.
Unit-side cable
Vehicle-side cable
Clarion Co., Ltd.
|